Home Repair
How to Unclog a Drain
Clear a slow or stopped sink or tub drain with hot water, a plunger, a drain snake or by cleaning the P-trap — plus what not to pour down it and how to tell when the problem is the main line.
A slow drain is almost always a local problem: hair and soap in a bathroom sink or tub, grease and food in a kitchen sink. Most clogs sit within a few feet of the drain opening — at the stopper, in the P-trap, or just past it — which is why simple tools usually win.
Work from the gentlest fix to the most involved. Many drains clear at the stopper or with a plunger, and you'll only need to take the trap apart if those don't work.
Pick the right method
| Symptom | Likely cause | Start with |
|---|---|---|
| Bathroom sink slow, stopper covered in hair | Hair and soap at the stopper | Clean the stopper, then a barbed drain strip |
| Tub or shower draining slowly | Hair just below the drain | Remove the cover and pull hair; then a snake |
| Kitchen sink slow after cooking | Grease and food in the trap or wall pipe | Hot water and dish soap, then plunge, then clean the trap |
| Sink won't drain at all | Clog in the trap or arm | Plunge, then clean the trap and snake the wall pipe |
| Several drains slow, toilet gurgles | Blockage in the main drain line | Stop and call a plumber or drain service |
About the tools
A plunger and a short hand auger handle most household clogs. Our roundup of drain snakes compares hand-crank and drill-powered augers by length and cable thickness, and plastic drain strips are a cheap first try for hair. A wet/dry vacuum set to liquid mode can also pull a clog back out of a sink if you seal the nozzle over the drain.
If your tub or shower has a cover that won't come off, see how to remove a shower drain cover. For a stopped-up toilet, use a flange plunger and the steps in how to unclog a toilet.
When it's the main line
Every fixture in your house drains into one main sewer line. If that line is blocked — by tree roots, a collapsed section, or a buildup of wipes and grease — the lowest drains in the house back up first, often the basement floor drain or a ground-floor tub. Plunging a sink won't help, and running more water makes the backup worse.
Stop using water, and look for the main cleanout: a capped pipe, usually 3 or 4 inches across, in the basement, crawlspace, garage or outside near the foundation. Opening it under pressure can release sewage, so this is a good point to hand the job to a plumber with a powered sewer machine and a camera.
Step by step
- 1
Figure out how far the clog goes
Run water in the other fixtures nearby. If only one sink or tub is slow, the clog is in that fixture's drain or trap and you can handle it. If several drains are slow, or the toilet gurgles when the sink drains, jump to the main-line section below before you plunge anything.
- 2
Clear the stopper and the top of the drain
Pull out the pop-up stopper or unscrew the strainer and clean off the hair and gunk. A barbed plastic drain strip pushed down a few inches and pulled straight up often removes a bathroom sink clog on its own.
- 3
Flush with hot tap water and dish soap
Squeeze a good squirt of dish soap into the drain, then pour in a few quarts of the hottest water from your tap. This loosens grease in kitchen drains. Skip boiling water if you have PVC pipes or a porcelain sink — see the safety note.
- 4
Plunge the drain
Leave a couple of inches of water in the basin so the plunger cup is submerged. Plug the overflow hole with a wet rag (and the other bowl of a double kitchen sink) so pressure goes down the drain instead of out. Push down gently to seat the cup, then pump hard 15–20 times and pull off sharply. Repeat two or three rounds.
- 5
Clean the P-trap
Put a bucket under the U-shaped pipe below the sink. Loosen the two slip nuts by hand or with channel-lock pliers, drop the trap into the bucket and clean it out with a brush. Check the washers, then reassemble hand-tight plus a quarter turn and run water to check for drips.
- 6
Run a drain snake into the wall pipe
With the trap off, feed the snake into the pipe that goes into the wall. When you feel resistance, tighten the lock and crank the handle clockwise while pushing gently. Work it back and forth, then pull it out slowly — the clog usually comes out wrapped around the tip. For a tub, snake through the overflow opening or the drain after removing the cover.
- 7
Reassemble and test with a full basin
Reconnect the trap, fill the sink or tub partway and pull the plug. A cleared drain empties fast and quietly. Watch under the sink for a minute to make sure the slip nuts aren't weeping.
- 8
Keep it clear
Use a hair catcher in showers and bathroom sinks, scrape greasy pans into the trash instead of the sink, and run hot water for 30 seconds after using a kitchen drain. An enzyme cleaner once a month can help keep buildup down, though it won't clear a full clog.
Common mistakes
- Pouring boiling water into PVC pipes or a porcelain sink, which can soften plastic joints or crack the fixture.
- Plunging without blocking the overflow hole, so all the pressure escapes out the top.
- Using a chemical drain cleaner and then plunging or opening the trap, which can splash caustic water on your skin and eyes.
- Mixing two different drain cleaners, or adding vinegar after a chemical cleaner — the reaction can release heat and fumes.
- Overtightening plastic slip nuts with pliers, which cracks them and causes leaks.
- Snaking the same fixture over and over when several drains are slow — that points to the main line.
Frequently asked questions
Does baking soda and vinegar actually unclog a drain?
Not much. The fizz looks dramatic, but it mostly neutralizes itself. It can freshen a smelly drain or loosen light film, but it won't dissolve a hair clog or a grease plug. A plunger, a drain strip or a snake does far more.
Is it safe to pour boiling water down a drain?
It's okay for metal pipes in a stainless steel sink. Avoid it with PVC drain pipes, which are rated for lower temperatures and can soften at the joints, and with porcelain or glazed sinks and toilets, which can crack from sudden heat. Very hot tap water is the safer choice.
Are chemical drain cleaners bad for pipes?
They can be. Strong lye or acid cleaners generate heat and can damage old metal pipes, rubber parts and septic systems, and they often fail on solid clogs — leaving a sink full of caustic water. If you've used one and the drain is still blocked, tell the plumber before they start.
How do I know if it's a main line clog?
Warning signs are several fixtures backing up at once, water coming up in the tub or shower when you flush, a gurgling toilet when a sink drains, or sewage odor from floor drains. Those mean the blockage is past the individual fixture drains.
Can I use a toilet plunger on a sink?
A flange (toilet) plunger works on a sink if you fold the flange up inside the cup, but a flat cup plunger seals better on flat surfaces. For hygiene, many people keep a separate plunger for sinks.
Related guides
- GuideHow to Remove a Sink Drain (Bathroom and Kitchen)Remove a bathroom pop-up drain or a kitchen basket strainer step by step: stopper, pivot rod, P-trap, locknut and flange — plus how to reinstall it without leaks.
- GuideHow to Unclog a ToiletStop the overflow, then clear a clogged toilet with a flange plunger, dish soap and hot water, or a closet auger — and what never to pour or push into the bowl.
- GuideHow to Remove a Shower Drain CoverIdentify your shower or tub drain cover — screw-in, snap-in, screwed grate, twist-and-lift or toe-touch — then remove it, clear the hair clog and put it back.