Skip to content

Cleaning

How to Clean a Nespresso Machine

Keep your Nespresso OriginalLine or Vertuo brewing hot, fast and tasty — daily and weekly cleaning, the rinse cycle, how to descale, how often, and how to clean the Aeroccino frother.

A Nespresso machine is about as low-maintenance as coffee gets, but it isn't no-maintenance. Coffee oils build up in the brew path, used capsules and drip water grow mold, and minerals from your water slowly scale up the heater. The result is slower, cooler, worse-tasting coffee.

A few seconds of daily care, a quick weekly wash and a descale every few months will keep it running like new. The steps below work for both the OriginalLine (small espresso capsules) and Vertuo (larger barcoded capsules) ranges — but button sequences vary by model, so keep your manual handy.

Cleaning schedule at a glance

WhenWhat to do
After every useRinse the Aeroccino jug and whisk
DailyEmpty capsule container and drip tray; refill fresh water; run a water-only rinse
WeeklyWash the water tank, lid, drip tray and capsule container with warm soapy water
Every few monthsDescale (sooner with hard water or when the machine's alert comes on)

OriginalLine vs Vertuo descaling

The descaling process is the same idea on both ranges: fill the tank with diluted descaling solution, put the machine in descaling mode, run the solution through, then rinse with fresh water. What changes is how you get into and out of descaling mode — usually by holding one or more buttons, or on some models turning a lever or closing the head, until the lights blink in a set pattern.

Nespresso publishes manuals for each model, and many machines have the model name on the base or under the water tank. Look up the exact sequence rather than following a generic video for a different machine.

Related jobs

Have a Keurig as well? See how to clean a Keurig for its needle and reservoir routine. Doing a full kitchen deep clean? Next up: steam-clean the microwave, clean the dishwasher filter and clean the oven.

Step by step

  1. 1

    Empty the capsule container and drip tray daily

    Used capsules sit wet, and coffee residue grows mold fast. Empty the used-capsule container and the drip tray at the end of each day, rinse them, and let them air-dry. On many machines the drip tray grid and container slide out together.

  2. 2

    Refresh the water tank

    Pour out water that has been sitting overnight and refill with fresh, cold water. Once a week, wash the tank and lid with warm soapy water, rinse well, and let it dry. Check your manual before putting any part in the dishwasher.

  3. 3

    Wipe the capsule area and coffee outlet

    With the machine off and cool, open the head and wipe the capsule holder, the area around the outlet and the inside of the lid with a damp cloth. Use a soft brush for dried coffee. Don't poke the piercing points or the outlet with sharp objects.

  4. 4

    Run a rinse cycle without a capsule

    Place a cup under the outlet, close the machine with no capsule inside, and run a water-only cycle (on OriginalLine, a lungo-size shot is typical; Vertuo machines also run water through when closed without a capsule). This flushes coffee oils from the brew path. Do it daily or whenever the coffee tastes off. Many Vertuo models also have a dedicated cleaning cycle — see your manual.

  5. 5

    Prepare for descaling

    Turn the machine on, then remove and empty the capsule container and drip tray. Eject any capsule. Fill the water tank with descaling solution and fresh water in the amount the descaler's directions specify, and put a container of at least 1 liter under the outlet.

  6. 6

    Enter descaling mode for your model

    Most machines enter descaling mode by holding down a button (or a combination of buttons) for several seconds until the lights blink in a specific pattern. The exact sequence differs between models and generations, so look it up in your model's manual — guessing can start a normal brew instead.

  7. 7

    Run the descaling solution through

    Start the cycle as your manual describes. The machine pumps the solution through in stages. When the tank empties, pour the used solution from the container back into the tank and run it again if your manual says to.

  8. 8

    Rinse thoroughly

    Empty and rinse the water tank, then fill it with fresh water up to the max line. Empty and rinse the container, drip tray and capsule container. Run the rinse step in descaling mode so clean water flushes the descaler out completely.

  9. 9

    Exit descaling mode and dry

    Exit descaling mode using the button sequence in your manual (on many machines it exits automatically or after you hold the button again). Wipe the machine down, let parts dry, and brew one water-only cycle before your next coffee.

  10. 10

    Clean the Aeroccino milk frother after every use

    Unplug the frother or lift the jug off its base. Remove the whisk and wash it and the jug interior with warm soapy water and a soft sponge — never an abrasive pad, which scratches the non-stick coating. Never put the base in water. Check your model's manual before putting the jug or whisk in the dishwasher.

Common mistakes

  • Descaling with vinegar, which Nespresso does not recommend and which can leave residue and taste behind.
  • Skipping the rinse after descaling, so the first few coffees taste sour or chemical.
  • Pressing random buttons to find descaling mode instead of checking the manual for your model.
  • Leaving used capsules and drip tray water in the machine for days, which leads to mold.
  • Scrubbing the Aeroccino jug with an abrasive sponge or submerging the electric base.

Frequently asked questions

How often should I descale my Nespresso machine?

Follow the descaling alert if your machine has one. As a general rule, Nespresso suggests descaling every few months or after a few hundred capsules, and more often if your water is hard. If you notice slower flow, lukewarm coffee or noisier brewing, it's probably overdue.

Can I descale a Nespresso with vinegar?

Nespresso recommends its own descaling solution and advises against vinegar, which can leave residue and may harm internal parts over time. A dedicated descaling solution labeled safe for capsule or espresso machines is the safer choice.

What's the difference between cleaning OriginalLine and Vertuo machines?

Daily care is the same: empty the capsule container and drip tray, refresh the water and run a rinse. The main differences are how you enter descaling mode and, on many Vertuo models, a separate cleaning cycle. Both are model-specific, so use the manual for your exact machine.

Why does my Nespresso coffee taste bitter or weak?

Old coffee oils in the brew path, stale water in the tank, or scale buildup are the usual causes. Run a water-only rinse, refill with fresh water, and descale if it's been a few months.

How do I clean the Aeroccino frother?

Rinse it right after each use so milk doesn't dry onto the coating. Remove the whisk, wash the jug and whisk with warm soapy water and a soft sponge, and dry them. Keep the base dry and check your manual before using a dishwasher.