Skip to content

Cleaning

How to Clean a Dishwasher (Filter, Spray Arms and Gasket)

Fix cloudy dishes, gritty residue and bad smells by cleaning your dishwasher's filter, spray arms and door gasket, then running a cleaning cycle — about an hour start to finish.

Dishwashers clean themselves less than you'd think. Many newer models use a manual filter instead of a self-cleaning grinder, which means food particles, grease and bits of label collect in the bottom of the tub until you take them out. That's what usually causes gritty glasses, cloudy dishes, slow draining and a sour smell when you open the door.

A deep clean takes about an hour, but most of that is the machine running. The hands-on part is pulling the filter, clearing the spray arms and wiping the gasket.

Troubleshooting: what the symptom tells you

SymptomMost likely causeWhat to clean or check
Gritty bits on dishesClogged filter recirculating foodFilter and filter housing
Spots where dishes stayed dirtyBlocked spray arm holes or an arm that won't spinSpray arms; check for tall items blocking them
Sour or musty smellFood in the filter, grime in the gasketFilter, gasket, bottom of door
Cloudy white filmHard-water mineralsRun a cleaner cycle; use rinse aid
Standing waterClogged filter or drain pathFilter, drain hose, disposal connection

Cleaner, vinegar or baking soda?

A dishwasher cleaner made for the job is the most direct option and is what many manufacturers recommend, especially for mineral buildup. White vinegar in a dishwasher-safe cup on the top rack is a cheap alternative if your manual doesn't advise against it. Baking soda is mild and good for freshening the tub as a separate short cycle. None of these replaces cleaning the filter, which is the step that fixes most problems.

If your dishwasher drains through a garbage disposal, run the disposal before starting a cleaning cycle so the shared drain line is clear. Our guide to resetting a garbage disposal helps if it hums or won't turn on.

Keep it running clean

  • Scrape plates into the trash, but don't pre-rinse heavily — most detergents work best with a little food to act on.
  • Run the kitchen tap hot before starting a cycle.
  • Clean the filter monthly, or whenever you see residue.
  • Leave the door cracked for a while after the cycle to let the tub dry.

Step by step

  1. 1

    Empty the dishwasher and pull out the bottom rack

    Remove all dishes and slide the lower rack out completely so you can reach the floor of the tub. Pick out any visible food, glass shards or labels from around the drain. Wear gloves in case there's broken glass.

  2. 2

    Remove the filter

    Most modern dishwashers have a cylindrical filter in the floor of the tub, under or next to the lower spray arm. It usually twists counterclockwise a quarter turn and lifts out, and there may be a flat mesh screen underneath. Your manual shows the exact layout for your model.

  3. 3

    Clean the filter

    Rinse the filter under warm running water, then scrub it gently with a soft brush and a drop of dish soap to remove grease and food. Don't use wire brushes or scouring pads, which can tear the mesh. Wipe out the filter housing before putting the filter back and locking it in place.

  4. 4

    Clear the spray arms

    Check the spray arm holes for clogs. Many arms unclip or unscrew for removal — check your manual. Poke debris out of the holes with a toothpick, rinse the arms, and make sure they spin freely once reinstalled.

  5. 5

    Wipe the door gasket and door edges

    Wipe the rubber gasket around the door opening with a damp cloth and a little dish soap, getting into the folds. Then clean the bottom edge of the door and the sides of the tub outside the gasket, where drips collect and never get washed.

  6. 6

    Run a cleaning cycle with dishwasher cleaner or vinegar

    Run the kitchen tap until the water is hot. With the dishwasher empty, either use a dishwasher cleaner following its label, or place a dishwasher-safe cup with 1 cup of white vinegar upright on the top rack if your manual allows vinegar. Run the hottest cycle.

  7. 7

    Finish with a baking soda rinse

    Sprinkle about 1 cup of baking soda across the bottom of the empty tub and run a short hot cycle. It helps freshen the tub and loosen leftover stains. Do this as a separate cycle — not in the same one as a commercial cleaner unless its label says to.

  8. 8

    Clean the outside and controls

    Wipe the door front and control panel with a soft cloth and mild soapy water. On stainless steel, wipe with the grain. Spray cleaner onto the cloth rather than onto the controls.

Common mistakes

  • Never cleaning the filter — on many newer dishwashers it's a manual filter that needs cleaning by hand.
  • Mixing chlorine bleach with vinegar or with a dishwasher cleaner, which can release toxic fumes.
  • Using bleach in a stainless steel tub, which can discolor or damage the steel.
  • Scrubbing the filter mesh with a wire brush and tearing it.
  • Running a cleaning cycle with dishes still inside.

Frequently asked questions

How often should I clean my dishwasher filter?

Check your manual, but many manufacturers suggest about once a month, or more often if you don't scrape plates. If you notice gritty residue, standing water or a smell, clean it right away.

Is it safe to use vinegar in a dishwasher?

An occasional cup of vinegar in a dishwasher-safe cup is a common cleaning method, but some manufacturers recommend their own cleaner instead and caution that frequent acid exposure can wear rubber parts. Follow your manual, and never use vinegar in the same cycle as bleach.

Why does my dishwasher smell bad?

The usual causes are food trapped in the filter, grease in the door gasket, or standing water from a slow drain. Clean the filter and gasket, run a cleaning cycle, and leave the door cracked open for a while afterward so the tub dries.

Why are my dishes coming out cloudy or gritty?

Gritty residue usually points to a dirty filter or clogged spray arms recirculating food. A cloudy white film is often hard-water mineral buildup — a dishwasher cleaner and rinse aid help, and so does making sure the water is hot when the cycle starts.

Why is there water left in the bottom of my dishwasher?

A small amount around the filter is normal on many models. More than that usually means a clogged filter, a kinked drain hose, or a blocked garbage disposal connection. On a newly installed disposal, the drain knockout plug may never have been removed.